HP ProCurve 5300xl Series Management Manual page 335

Using QoS Classifiers To Configure Quality of Service for Outbound Traffic
For example, suppose you wanted to assign this set of priorities:
Source-Port DSCP
A2 000111
B1-B3 000101
B4, C2 000010
1. Determine whether the DSCPs already have priority assignments, which
could indicate use by existing applications. This is not a problem as long
as the configured priorities are acceptable for all applications using the
same DSCP. (Refer to the "Note On Changing a Priority Setting" on page
8-65. Also, a DSCP must have a priority configured before you can assign
any QoS classifiers to use it.)
Figure 8-33. Display the Current Configuration in the DSCP Policy Table
2. Configure the priorities for the DSCPs you want to use.
Figure 8-34. Assign Priorities to the Selected DSCPs
Quality of Service (QoS): Managing Bandwidth More Effectively
Priority
7
5
1
The DSCPs for this
example have not yet
been assigned an
802.1p priority level.
Priorities
Configured in
this step.
8-61