HP ProCurve 5300xl Series Management Manual page 140

PIM-DM (Dense Mode) on the 5300xl Switches
Configuring PIM-DM on the Series 5300xl Switches
5-14
To configure global-level PIM operation for the "5308XL #1" routing switch,
you would use the commands shown in figure 5-3, below.
Using show config displays the configuration changes
resulting from the above commands.
Figure 5-3. Example of Configuring PIM-DM on a Routing Switch at the Global
Level
Enables IP routing.
Enables multicast routing.
Enables PIM.
Enables RIP.
Configures a non-default State
Refresh timer.
Sets an SNMP trap to notify an
SNMP management station if the
hardware multicast routing table
fills with active flows.