Defining Redistribution Filters - HP ProCurve 5300xl Series Management Manual

IP Routing Features
Configuring OSPF
11-48
Simple password – Use the area <num> | <ip-addr> virtual-link <ip-addr>
■
authentication-key <password> command. The simple password method of
authentication requires you to configure an alphanumeric password on
an interface. The simple password setting takes effect immediately. All
OSPF packets transmitted on the interface contain this password. Any
OSPF packet that is received on the interface is checked for this pass-
word. If the password is not present, then the packet is dropped. The
password can be up to eight characters long.
MD5 – Use the area <num> | <ip-addr> virtual-link <ip-addr> md5-auth-key-
■
chain <chain-name-str> command. The MD5 method of authentication uses
key chains that you configure through the Key Management System (KMS
– described in your switch Security Guide). The <chain-name-str> is the
name of the key chain that you have previously configured by using the
KMS commands.
Hello Interval: The length of time between the transmission of hello packets.
The range is 1 – 65535 seconds. The default is 10 seconds.
Retransmit Interval: The interval between the re-transmission of link state
advertisements to router adjacencies for this interface. The range is 0 – 3600
seconds. The default is 5 seconds.
Transmit Delay: The period of time it takes to transmit Link State Update
packets on the interface. The range is 0 – 3600 seconds. The default is 1 second.
Dead Interval: The number of seconds that a neighbor router waits for a hello
packet from the current routing switch before declaring the routing switch
down. The range is 1 – 65535 seconds. The default is 40 seconds.

Defining Redistribution Filters

Route redistribution imports and translates different protocol routes into a
specified protocol type. Redistribution is supported for only static routes and
directly connected routes. Redistribution of any other routing protocol into
OSPF is not currently supported. When you configure redistribution for OSPF,
you can specify that static or connected routes are imported into OSPF routes.
Likewise, RIP redistribution supports the import of static or connected routes
into RIP routes.
To configure for redistribution, define the redistribution tables with restrict
redistribution filters. In the CLI, use the restrict command for OSPF at the
OSPF router level.