HP ProCurve 5300xl Series Management Manual page 155

Figure 5-12. Example Output for the "5304XL #1" Routing Switch in Figure 5-4 on Page 5-20
Displaying PIM Data and Configuration Settings on the Series 5300xl Switches
Syntax: show ip pim [interface [< vid >]]
Displays the current configuration for the specified VLAN
(PIM interface). Refer to table 5-1, below.
Table 5-1. PIM Interface Configuration Settings
Field Default Control Command
VLAN n/a
IP n/a
Mode dense
Hello Interval (sec) 30
Hello Hold Time 105
Hello Delay 5
Graft Retry Interval 3
(sec)
PIM-DM (Dense Mode) on the 5300xl Switches
vlan < vid > ip pim
vlan < vid > ip pim < all | ip-addr >
n/a; PIM Dense only
ip pim hello interval < 5 - 30 >
The routing switch computes this value from the current "Hello
Interval" and includes it in the "Hello" packets the routing
switch sends to neighbor routers. Neighbor routers use this
value to determine how long to wait for another Hello packet
from the routing switch. Refer to the description of the Hello
Interval on page 5-15.
vlan < vid > ip pim hello delay < 0 - 5 >
vlan < vid > ip pim graft-retry-interval < 1 - 10 >
5-29