HP ProCurve 5300xl Series Management Manual page 111

Figure 4-1. Example Listing of IGMP Configuration for All VLANs in the Switch
Viewing the Current IGMP Configuration. This command lists the IGMP
configuration for all VLANs configured on the switch or for a specific VLAN.
Syntax: show ip igmp config
Displays IGMP configuration for all VLANs on the switch.
show ip igmp vlan < vid > config
Displays IGMP configuration for a specific VLAN on the switch,
including per-port data.
(For IGMP operating status, refer to the section titled "Internet Group Man­
agement Protocol (IGMP) Status" in appendix B, "Monitoring and Analyzing
Switch Operation" of the Management and Configuration Guide for you
switch.)
For example, suppose you have the following VLAN and IGMP configurations
on the switch:
VLAN ID VLAN Name
1 DEFAULT_VLAN
22 VLAN-2
33 VLAN-3
You could use the CLI to display this data as follows:
Multimedia Traffic Control with IP Multicast (IGMP)
CLI: Configuring and Displaying IGMP
IGMP Forward with
Enabled High Priority
Yes No
Yes Yes
No No
Querier
No
Yes
No
4-7