Pto Shaft Drive Engagement Lever - Zetor MAJOR CL Operator's Manual

PTO shaft drive engagement lever

Rear PTO shaft is engaged with a lever (1) shaft drive
placed on the left side of driver's seat.
a - dependent revolutions of PTO
with PTO shaft drive via
gearbox - revolutions are
dependent on the engaged
gear
n - Neutral position
b - independent revolutions of PTO
shaft drive - revolutions are
dependent on engine
revolutions
Gear shifting is done with engine at standstill and engaged
manual clutch lever.
PTO shaft revolutions 540 and 1000 rpm shifting lever
Shifting 540 or 1 000 revolutions of rear PTO shaft is done
with a lever (1) placed on the outer side of tractor on rear
PTO shaft.
a - 540 rpm
b - 1 000 rpm
Shifting is done with an engine at standstill and lever of
engaging PTO shaft drive in (n) position.
PTO shaft revolutions need to be selected
depending on the prescribed revolutions from
aggregated machines.
The button for activation of the front PTO shaft
The front PTO shaft is activated and deactivated with the
switch on the instrument panel. Activation of the switch is
indicated with the activated symbol on the switch.
The switch is equipped with a mechanical lock (1) against
accidental switching. When activating the switch, press
the lock (1) in the direction of the arrow.
When starting the engine, the switch must be
deactivated.
Working modes of PTO shafts
The tractor is equipped with two working modes of PTO shafts. The selected mode is indicated on the
display of the instrument panel.
A - common working mode with the PTO shaft
the PTO shaft is rotated regardless the tractor is going or not; the operator must sit on the driver's seat
B - the stationary working mode with the PTO shaft - it is used when the tractor is used as a stationary drive
unit, e.g. for the drive of chippers, etc.
the PTO shaft is rotated if the tractor is not going and it is braked with the hand brake; the operator must not
sit on the driver's seat
DRIVE OF AGRICULTURAL MACHINERY
63
NM13N004
NM13N005
MCL18N026