Starting The Engine - Zetor MAJOR CL Operator's Manual

DRIVING OPERATION

Starting the engine

MCL18N013
1. The operator must sit on the driver's seat (the start protection will be activated).
2. Press the clutch pedal (the start protection will be activated).
3. Move the gear shift lever to the neutral position (the start circuit breaker is switched).
4. Pull the manual clutch lever (the start protection will be activated).
5. Set the fuel manual regulation lever to the idling position.
6. Insert the key in the switch box. Switch the key of the switch box from the position '0' to the position 'I'. The
glowing signal lamp will be activated. Wait until the glowing signal lamp goes out (the time depends on the
temperature of the cooling liquid).
7. Immediately after the lamp goes out (5 s max.) turn the key from 'I' position to 'II' position (start).
8. After starting the engine, immediately release the key and it is automatically returned to the position 'I'. Do
not perform starting for a longer period than 15 s.
If engine does not start
Return the key to position '0', wait 30 seconds and repeat
the start.
A maximum of 6 starting cycles is allowed (15 seconds
start and 30 seconds interruption is one cycle). Another
engine start is allowed after the starter cools off to
surrounding temperature.
Never help a stopping tractor with a starter.
There is a danger of starter damage.
NM13N091
40