Manipulation With Starter - Zetor MAJOR CL Operator's Manual

Manipulation with starter

It is forbidden to start by short circuiting starter
clamps! Tractor is started only from driver's seat!
With any manipulation or starter repair it is necessary
to disconnect minus battery pole and all shifting
levers including PTO shaft shifting lever must be in
neutral position!
Starter contacts are covered with a cap.
Immediately after start
When the engine is started, set the revolutions
to 900-1100 rpm and leave the engine idling without
load for ca. 2 minutes.
During this time, perform checking of lubrication, charging
(signal lamps must turn off) and other functions ensuring
proper operation of the engine. The time of engine
operation without load must be adhered to, especially in
winter period.
Engine heating
Do further heating of the engine when driving. Heating engine by lengthy idle run or abrupt
revolutions increase is harmful to the engine. If the temperature of coolant has not reached 45°C, do
not overcome engine revolutions over 2,000 rpm.
DRIVING OPERATION
41
NM13N093
MCL18N015