Read Authorization Password - Kenwood TK-3180 Function Reference

5.2 Read Authorization
Password
This password protects the configuration data and prevents
the operating frequencies from being read by unauthorized
persons.
You must enter the Read Authorization Password when
reading the configuration data from the transceiver using
KPG-89D. You cannot read the configuration data unless
the correct Password is entered.
You cannot start cloning the configuration data unless the
correct Read Authorization Password is entered when the
Password is configured on the master transceiver.
You can configure the Read Authorization Password
using KPG-89D You can configure the Read
Authorization Password using any numbers between 0
and 999999.
You can enter the Read Authorization Password using the
Mic Keypad on the TK-7180/ 8180 or 12-keypad of the
TK-2180/ 3180. You can also enter the password using
the Selector or PF keys.
!
Transceiver Operation
#
Using Mic Key or 12/16-key keypad
1. Press the Mic Keypad or keys on the 12/16-key
keypad and enter the password.
2. Press [S] or [*] when you complete entering the
password.
When the correct password is entered, the
Master Transceiver Mode becomes ready for
Cloning.
"CLONE LOCK" appears on the LCD again if the
wrong password is entered and the transceiver
returns to Password Entry Mode.
#
Using the Selector or PF keys
1. Select a number using the Selector or [
[ ].
The selected characters blink.
2. Press [C] to confirm the entered characters.
The entered character stops blinking and
becomes solid on the display.
3. Repeat the steps 1 and 2 to enter the entire
password.
4. Press [S] or [*] after entering the password.
When the correct password is entered, the
Master Transceiver Mode becomes ready for
Cloning.
"CLONE LOCK" appears on the LCD again if
the wrong password is entered and the
transceiver returns to Password Entry Mode.
Note: Following keys can be used to enter the Read
Authorization Password.
Version: 1.11
Key Name
Selector/ [
[Side 1]/ [
[S]
[A]
[B]
[C]
[Side 2]/ [!]
[0] - [9]
[*]
[#]
PTT switch
!
Configuration using KPG-89D
• Configuring the Read Authorization Password
(Refer to FPRG 6.7.1 Common-Page 1 tab - Read
Authorization Password.)
• Configuring the Clone function (Refer to FPRG
6.7.2 Common-Page 2 tab - Clone.)
]/
Function Reference
5 PASSWORD FUNCTION
Table 5-2 Key Operation
Operation
Increase/decrease the number
]/ [ ]
(0 - 9)
The transceiver returns to the
]
"CLONE LOCK" display.
Password authorization
Press: Delete a number.
Hold: Delete all numbers.
Confirm the selected value and the
number.
Enter the Digit number.
Password authorization
Press: Delete a number.
Hold: Delete all numbers.
31