Priority 2/ Priority 2 Zone-Ch; Revert Ch/Gid - Kenwood TK-3180 Function Reference

23 SCAN
3. Press [C].
The Priority Channel alternates in the following
order.
Normal > Priority 1 > Priority2 > Prirority1 & 2 >
Normal ...
TK-2180/ 3180
TK-7180/ 8180
4. Press [S].
The selected channel is configured as the
Priority Channel and the display returns to the
channel display.
TK-2180/ 3180
TK-7180/ 8180
!
Configuration using KPG-89D
• Configuring the Priority 1 (Refer to FPRG 6.9.1
Priority 1.)
• Configuring the Priority 1 Zone-CH (Refer to
FPRG 6.9.3 Priority 1 Zone-CH.)

23.7.5 Priority 2/ Priority 2 Zone-CH

This function allows you to configure the high priority
Zone/Channels. You can configure the following
functions for Priority 2.
Table 23-5 Priority 2 Operation
Priority 2
None No channel is configured as the Priority 2.
You can use the Priority 2 Zone-CH configured
Fixed
using the KPG-89D as Priority 2.
132
Operation
Function Reference
Priority 2
You can configure the selected channel as
Selected Priority 2. You cannot select the Priority 2 using
the KPG-89D.
The channel selected by a user is configured as
Priority 2. The transceiver enters Priority
Operator
Configuration Mode when the PF Scan key is
Selectable
pressed and held for more than 2 seconds.
(Refer to 23.7.4 Priority 1/ Priority 1 Zone-CH.)
Note: You cannot configure the Priority 2 Zone - CH when
"Selected" is selected in the Priority 2.
!
Configuration using KPG-89D
• Configuring the Priority 2 (Refer to FPRG 6.9.2
Priority 2.)
• Configuring the Priority 2 Zone-CH (Refer to
FPRG 6.9.4 Priority 2 Zone-CH.)

23.7.6 Revert CH/GID

This function allows you to configure the Zone-CH/GID
that is transmitted when the PTT switch is pressed during
scan.
You can configure the Revert CH/GID using KPG-89D.
The Revert CH/GID function works as below.
Table 23-6 Revert CH/GID Operation
Configuration During Scan
The last received
Last Called
Zone-CH/GID
The last used Zone-
Last Used
CH/GID
The last selected Zone-CH/GID before
Selected
activating scan
The last selected
Selected + Talk
Zone-CH/GID before
Back
activating scan
Priority 1 Priority 1 Channel
Priority 1 +
Priority 1 Channel
Talkback
Priority 2 Priority 2 Channel
Priority 2 +
Priority 2 Channel
Talkback
Note: The next Zone-CH/GID of the Last Called Zone-CH/GID or
the Last Used Zone-CH/GID is stored even if the transceiver
is turned OFF. In this case, the Revert CH/GID is also
stored.
• The last received CH/GID
• The last used CH/GID
Operation
While Scan Pauses
The Zone-CH/GID on
which the transceiver
pauses scan
The Zone-CH/GID on
which the transceiver
pauses scan
The Zone-CH/GID on
which the transceiver
pauses scan
The Zone-CH/GID on
which the transceiver
pauses scan
The Zone-CH/GID on
which the transceiver
pauses scan
Version: 1.11