Vgs; Auto Recording; Voice Memo (Manual Recording) - Kenwood TK-3180 Function Reference

31 VGS

This function allows a user to record and playback
recorded voice. It can be used for the Voice Guide
function and the GPS data storage function at the same
time.

31.1 Auto Recording

This function allows a user to automatically record the
transmitted or received voice.
The user can record the following types of audio signals.
•
Audio signal on the input line of the microphone while
the PTT switch is pressed.
•
Transmitted voice in the Emergency Mode
•
Received voice
The user can record the transmitted voice using the PTT
switch or in the Emergency Mode. The transceiver does
not record the transmitted voice with the Ext. PTT,
Transpond, or data transmission.
The user can playback and listen to the stored voice data
using the Message Playback function.
Message Playback.)
You can configure the Auto Recording duration to 30
seconds or disable the function. You cannot configure
this function when "Disable" is selected.
Note:
" A maximum recording time is 300 seconds (Auto Recording/
Voice Memo/ Auto Reply Message).
" The Auto Recording function is disabled when Voice Memo
Mode/ Auto Reply Message Mode/ Message Playback Mode is
enabled.
" When the GPS Data Storage function is enabled, the transceiver
may not record all incoming signals.
!
Transceiver Operation
1. The dot on the left appears while the Auto
Recording function is enabled.
TK-2180/ 3180
TK-7180/ 8180
158
!
31.2 Voice Memo
This function allows a user to manually record the
transmitted voice or received signal.
The user can record the following types of audio signals.
•
•
•
•
When the recording is completed, the voice data is
automatically stored in the VGS-1. The user can listen to
the stored voice data using the Message Playback
function.
You can enable/disable the Voice Memo, and/or configure
(Refer to 31.4
the maximum recording time and the storage function
options using KPG-89D.
Although you must configure the Voice Memo in steps of
30 seconds, the transceiver records each data in steps of
15 seconds.
For example, when the Voice Memo is configured for 60
seconds, the user can record a maximum of 4 voice
memos (15 seconds x 4 times).
Function Configuration
Stores the
messages
Note:
" A The maximum recording time is 300 seconds (Auto
" When the GPS Data Storage function is enabled, the transceiver
Function Reference
Configuration using KPG-89D
• Configuring the Auto Recording function (Refer to
FPRG 6.7.6 VGS-1 tab - Auto Recording.)
(Manual Recording)
Voice spoken into the microphone
Voice transmitted by pressing the PTT switch
Voice transmitted in the Emergency Mode
Received voice
(Refer to 31.4 Message Playback.)
Table 31-1 Voice Memo Configuration
You can configure the VGS-1
recording channel that is used to
record the Voice Memo in steps of
30 seconds.
Voice Disable/ 30 - A user cannot use the Voice
Memo 300 Memo function when "Disable" is
selected.
You can configure the recording
channel with a maximum of 300
seconds.
The message recorded in the new
recording channel is overwritten
Check
over on the old message. The
(Enable)
message recorded in the old
latest
channel is deleted.
received
When messages are stored to all
Uncheck recording channels, the
(Disable) transceiver will not record a new
message.
Recording/ Voice Memo/ Auto Reply Message).
may not be able to record all incoming signals.
Operation
Version: 1.11