Id List; Status Message Function; Sending The Status Message - Kenwood TK-3180 Function Reference

# When the ID is registered in the ID List
(Broadcast Call):
TK-2180/ 3180
TK-7180/ 8180
# When no ID is registered in the ID List
(Broadcast Call):
TK-2180/ 3180
TK-7180/ 8180

22.2.3 ID List

The transceiver uses an individual FleetSync ID to
perform communications if the FleetSync function is
enabled. The FleetSync IDs to be called must be stored
in the transceiver using KPG-89D. You can store up to
100 FleetSync IDs.
You can configure the following functions for the ID List
using KPG-89D.
Table 22-5 ID List Configuration
ID List
Configure the Fleet of the FleetSync ID. A user can
Fleet select ALL or the number between 100 and 349.
You can call to all IDs when ALL is selected.
Configure the ID of the FleetSync ID. A user can
select ALL or the number between 1000 and
ID
4999.
You can call to all IDs when ALL is selected.
You can configure the caller's ID name. A user
can configure a maximum of 10 characters.
ID Name
When the caller's ID Name is registered in the ID
List, the ID Name appears on the display.
Version: 1.11
Operation
Function Reference
ID List
Enable/disable the transmission to the receiving
party.
When the transmision is inhibited, the status does
not appear on the ID Selection window and a user
TX Inhibit cannot select the ID in Message Mode.
When receiving a call from the ID, the caller's ID
Name appears. In this case, the user cannot
make a call to the party even if the PTT switch or
the PF Ext. PTT (Voice) port is pressed.
!
Configuration using KPG-89D
•
Configuring the ID List (Refer to FPRG 6.12.4 ID
List tab.)

22.3 Status Message Function

This function allows a user to send status messages
(Status 10 - 99) by selecting the status message
numbers. With this function enabled, the dispatcher can
send a message to the transceiver.

22.3.1 Sending the Status Message

Following are the methods to send the Status Message.
Table 22-6 How to Send the Status Message
Status Message
The transceiver enters Message Mode
when the PF SelCall + Status key or the PF
Status key is pressed to send a Status
Message.
Message Mode A user can select the Status only by
pressing the PF Status key to send the
Status Message.
In this case, the receiving party is fixed to
the target Fleet/ID.
The transceiver sends the Status Message
assigned to the PF Call 1 - Call 6 keys. A
user can assign statuses to No. 1 - 90 of the
PF Key Direct Status List using the Key Assignment
function.
In this case, the receiving party is fixed to
the target Fleet/ID.
The transceiver sends the Status Message
when the status of the AUX IN changes
AUX IN (High> Low or Low > High).
In this case, the receiving party is fixed to
the target Fleet/ID.
The transceiver sends the message
Turning the configured with the KPG-89D when the
Transceiver ON/ transceiver is turned ON/OFF.
OFF In this case, the receiving party is fixed with
the target Fleet/ID.
22 FLEETSYNC
Operation
Description
99