Transmit; Conventional Group; Trunking System; Transmitting With Talk Around - Kenwood TK-3180 Function Reference

2.10 Transmit

2.10.1 Conventional Group

The transceiver transmits the programmed QT/DQT while
pressing the PTT switch to transmit. When the
transmitted QT/DQT code matches the QT/DQT code
configured in the receiving party's transceiver, you can
communicate with the receiving party.
The Reverse Burst and the Turn-off code in QT are
transmitted when releasing the PTT switch to close the
speaker of the receiving party's transceiver.
You must configure the Transmit Frequency and the
Encode ID using KPG-89D.
!
Transceiver operation
1. Select the Zone-Channel.
the Zone, 2.5 Changing the CH/GID.)
2. Confirm that the channel is available.
3. Speak into the microphone while pressing the PTT
switch.
4. Release the PTT switch to finish transmitting.
!
Configuration using KPG-89D
•
Configuring the Transmit Frequency (Refer to
6.3.4 Transmit Frequency.)
•
Configuring the QT/DQT Encode (Refer to 6.3.6
QT/DQT Encode.)

2.10.2 Trunking System

The transceiver sends the LTR ID while pressing the PTT
switch to transmit. The transceiver connects to the
repeater and waits to acknowledge the data that is
echoed back. If the data is correct, the transceiver
assumes the connection is properly established and re-
transmits a call to the receiving party.
When the transmitted LTR ID matches the LTR ID
configured in the receiving party's transceiver, you can
communicate with the receiving party.
The transceiver transmits the EOT data when the PTT
switch is released to close the squelch of the receiving
party's transceiver.
You must configure the Transmit Frequency and the
Encode ID using KPG-89D.
!
Transceiver Operation
1. Select the Zone-Group.
the Zone, 2.5 Changing the CH/GID.)
2. Press the PTT switch.
3. Speak into the microphone.
4. Release the PTT switch.
The transceiver returns to the receiving mode.
Version: 1.11
(Refer to 2.4 Changing
(Refer to 2.4 Changing
Function Reference
!
Configuration using KPG-89D
•
Configuring the Transmit Frequency (Refer to
6.4.4 Transmit Frequency.)
• Configuring the Encode ID (Refer to 6.6.3 Encode
ID.)
2.11 Transmitting with Talk
Around
This function allows you to communicate to another
transceiver without using a repeater.
Around.)
2.11.1 Conventional Group
!
Transceiver Operation
1. Select the Zone-Group.
the Zone, 2.5 Changing the CH/GID.)
2. Press the PF Talk Around key.
3. Press the PTT switch.
The transceiver transmits on the Receive
Frequency using the Receive QT/DQT instead of
the Transmit Frequency and the Transmit QT/DQT
to make a call.
2.11.2 Trunking System
!
Transceiver Operation
1. Select the Talk Around Group.
2. Press the PTT switch or the PF Talk Around key.
The transceiver transmits on the Receive
Frequency using the Receive QT/DQT instead of
the Transmit Frequency and the Transmit QT/DQT
to make a call.
2 BASIC OPERATION
(Refer to 13 Talk
(Refer to 2.4 Changing
17