Caller Id Stack; Id/Message Stack With Time Stamp; Message Memory; Timer Function - Kenwood TK-3180 Function Reference

22 FLEETSYNC

22.7.2 Caller ID Stack

This function allows the transceiver to store the IDs of the
callers to the Stack Memory.
The transceiver can store a maximum of three IDs. The
transceiver can stack a maximum of 15 messages (Status
Message and Short Message).
The user can reply to the displayed Caller ID by pressing
the PTT switch or the PF Ext. PTT (Voice) port in Caller
ID Stack Mode.
When the transceiver receives a call with FleetSync ID,
the " " icon blinks to notify the user that the ID is
stored. The user can enter Stack Mode to check the
stored FleetSync IDs.
The method to stack the IDs varies depending on the
Stores the latest received messages configuration.
(Refer to 22.7.1 Stores the Latest Received Messages.)
You can enable/disable the Caller ID Stack function using
KPG-89D.
!
Configuration using KPG-89D
• Configuring the Caller ID Stack (Refer to FPRG
6.12.2 General 2 tab - Caller ID Stack.)
22.7.3 ID/Message Stack with Time
Stamp
This function allows the transceiver to stack Caller ID,
Status Message, and Short Message with the received
time stamp.
You can configure the received time whether or not to be
stacked with the ID or message using KPG-89D.
!
Configuration using KPG-89D
•
Configuring the ID/Message Stack with Time
Stamp function (Refer to FPRG 6.12.2 General 2
tab - ID/ Message Stack with Time Stamp.)

22.7.4 Message Memory

This function allows the transceiver to stack Caller ID,
Status Message, and Short Message even if the
transceiver is turned OFF.
You can configure the message to be stored using KPG-
89D.
!
Configuration using KPG-89D
• Configuring the Message Memory (Refer to FPRG
6.12.2 General 2 tab - Message Memory.)
118

22.8 Timer Function

This function allows the transceiver's time to be adjusted.
A user can use this function to add the Time Stamp to the
received information.
Followings are the time adjustment functions.
Timer Function
Remote update
function of the
internal timer of the
transceiver over the
air
Note: This function may not be available for older versions of
transceivers. Refer to the PC Interface Protocol manual for
details before you perform this function.

22.9 Configuring the FleetSync

You can configure the following functions relating to
FleetSync using KPG-89D.
• Own Fleet/ID
•
Unit ID Encode Block
•
Interfleet Call
•
FleetSync Baud Rate
•
Auto Reset Timer
•
FleetSync II
•
Manual Dialing
• Group ID
• GTC Count
• Number of Retries
• Transmit Busy Wait Time
•
Maximum ACK Wait Time
•
ACK Delay Time
•
Transmit Delay Time (Receive Capture)
•
Data Transmit Modulation Delay Time
•
Random Access (Contention)
•
Unit ID Serial Output
• Selective Call Alert LED
• Message Display Type
• Alert Tone (Individual Call)
• Alert Tone (Other Selective Calls)
Function Reference
Table 22-19 Timer Function List
Function
This function allows a user to adjust the
time contained in the data according to
the clock Update request transmitted
over the air from the Base Station.
This function corrects the time of the
internal clock if the transceiver.
The user can adjust the internal clock of
the target transceiver in the same
system by using the base station time as
the standard time .
Version: 1.11