Dalsa Piranha ES-80-08k40-00-R User Manual page 97

Piranha ES-xx User Manual
Mnemonic
set binning vertical
set ccd d irection
set d igital offset
set exposure m od e
set fpn coeff
set fpn range
set low er threshold
Teledyne DALSA
Syntax Parameters
sbv
m
scd
i
sdo
t i
sem
m
sfc
x i
sfr
x x i
slt
i
Description
Sets the vertical binning value.
Available values are:
1 to 8 (ES-80)
1 to 4 (ES-82)
Refer to section 3.3.4 Increasing
Sensitivity w ith Binning on page 37 for
d etails.
Sets the CCD shift d irection w here:
0 = Forw ard TDI shift d irection.
1 = Reverse TDI shift d irection.
2 = Externally controlled d irection
control via Cam era Link control CC3.
Available only in TDI Mod e
Subtracts the input value from the
vid eo signal prior to FPN correction.
t = Tap value. 0 for all taps or 1-
number of CCD taps for ind ivid ual
tap selection.
i = Offset in a range from 0 to 511DN .
Refer to Setting Digital Offset on page62
for d etails.
Set the exposure m od e:
3 = External SYN C, m axim um
exposure tim e
7 = Internal program m able SYN C,
m axim um exposure tim e. Factory
setting.
Set the FPN coefficient.
x =pixel num ber w ithin the range 1 to
sensor pixel count.
i= FPN value w ithin the range 0 to 511
(12-bit LSB).
Refer to Perform ing FPN Correction on
page 62 for d etails.
Set a range of pixel FPN coefficients
x=first pixel num ber of the range.
x=last pixel num ber of the range
i=coefficient value in a range from 0 to
2048.
Refer to Setting a Range of FPN
Coefficients on page 62 for d etails.
The pixels below the low er threshold
are checked for and reported in the
end -of-line sequence in a range from 0-
4095. Refer to section 3.5.3 End -of-line
Sequence for d etails.
97
03-032-20070-02