Dalsa Piranha ES-80-08k40-00-R User Manual page 94

94
Mnemonic
correction set sam ple
d isplay pixel coeffs
end of line sequence
enable pixel
coefficients
get cam era m od el
get cam era param eters
get cam era serial
get cam era version
03-032-20070-02
Syntax Parameters
css
m
dpc
x1 x2
els
i
epc
i i
gcm
gcp
gcs
gcv
Piranha ES-xx User Manual
Description
The calculation is perform ed for all
sensor pixels but w arnings are only
applied to pixels in the region of
interest. This algorithm is useful for
achieving uniform output across
m ultiple cam eras.
4 = This algorithm is the sam e as 2 w ith
the exception that it only calculates
PRN U for the pixels w ithin the current
Region of Interest (ROI).
The second param eter is the target
value to use in a range from 1024 to
4055DN .
Set num ber of line sam ples averaged
for pixel coefficient calculations or for
gla
com m and . Values: 256,
outpu t of
512, 1024. Factory setting: 1024
Refer to Returning Averaged Lines of
Vid eo on page 77 for d etails.
Displays the pixel coefficients in the
ord er FPN , PRN U, FPN , PRN U, ...
x1 = Pixel start num ber
x 2= Pixel end num ber
in a range from 1 to sensor pixel
count.
Sets the end -of-line sequence:
0: Off
1: On
Refer to Refer to 3.5.3 End -of-line
Sequence for d etails.
Sets w hether pixel coefficients are
enabled or d isabled .
The first param eter sets the FPN
coefficients w here i is:
0 = FPN coefficients d isabled
1 = FPN coefficients enabled
The second param eter sets the PRN U
coefficients w here i is:
0 = PRN U coefficients d isabled
1 = PRN U coefficients enabled
Refer to section Enabling and Disabling
Pixel Coefficients on page 67 for d etails.
Read s the cam era m od el num ber.
Read s all of the cam era param eters.
Read the cam era serial num ber.
Read the firm w are version and FPGA
version.
Teledyne DALSA