Adjusting The Ez-Turn Sensor - Toro Greensmaster eFlex 2120 Operator's Manual

4
Installing the Handle
Retainers
Parts needed for this procedure:
2 Handle retainer
2 Hairpin cotter
Procedure
1. While supporting the handle, remove the cable
ties that secure the handle clamps to the side
plates (Figure 9).
1. Hairpin cotter
2. Pivot the handle to the desired operating position
and insert a handle retainer over the handle
clamp and into the matching holes in the side
plate (Figure 9).
3. Secure the clamp in position with a hairpin cotter
(Figure 9).
4. Repeat the procedure on the opposite side of
the handle.
5. Adjust the handle height to the desired position;
refer to Adjusting the Handle Height (page
Note:
The machine is shipped with the handle
adjusted to the lowest position. The machine is
traditionally operated with the handle telescoped
out to its maximum height.
Figure 9
2. Handle retainer
5
Adjusting the EZ-Turn
Sensor
No Parts Required
Procedure
1. Ensure that the machine is on a flat, level
surface with the traction drum on the ground.
2. Loosen the jam nuts on the sensor and adjust
the sensor so that 1 thread is visible past the
lower jam nut
g017355
1. Sensor light (on top)
2. Jam nuts
3. EZ-Turn sensor
4. Roller
3. Tighten the jam nuts to secure the sensor.
4. Place a 3.8 cm (1-1/2 inches) block under the
20). front cutting unit roller
5. Loosen the fasteners that secure the sensor
bracket to the frame
6. Start the machine; refer to
(page 24).
10
(Figure 10).
Figure 10
5. 3.8 cm (1-1/2 inches) block
6. Target plate
7. Bracket fasteners
8. Sensor bracket
(Figure 10).
(Figure 10).
Starting the Machine
g017357