Communication Connections; Rs232 In / Rs232 Out; Communication Port For Communication With Peripherals - Barco ATLAS 67 CS4 User Manual

5.1.16 Communication Connections

The following communication connections are available:

! RS232 in / RS232 out.

! Comm port for communication with peripheral (switchable between PPM and RC5)
! RC for remote cable connection with the RCU.
! MOUSE to control a PC with the projector remote control.
! TRIG: output voltage to control another device.
5.1.17 RS232 in / RS232 out
To connect a Computer, e.g. IBM PC (or compatible), Apple Macintosh to the RS 232 input of the
projector to allow communicate between the computer and the projector.
Applications:
remote control
data communications
Set up of the Baud Rate for Communication with a Computer:
see "change Baudrate PC" in chapter
5.1.18 Communication port for com munication with peripherals
This port can be configured to accept PPM or RC5 coded signals.
To change the port configuration see "800 Peripherals" in chapter
Connecting a RCVDS 05 to the projector:
! Up to 20 inputs with the RCVDS 05 and 90 inputs when RCVDS's are linked via the expansion
module.
! Serial communication with the projector.
! Remote control buttons on the RCVDS to control the projector (source selection and analog
settings).
! The selected source number will be displayed on a 2 digit display and the selected input mod-
ule will be indicated with a LED on the rear.
For more information about the use of the RCVDS 05, consult the owner's manual of the
RCVDS05, see
12.5.2 User's Manuals
Connecting a VS05 to the projector:
The VS05 (see
12.5.1 Optional Parts
sources and 1 RGB analog or component video source to the projector. In addition, the audio sig-
nal proper to the source, can be switched to an audio amplifier or the audio input of the projector.
For more information about the use of the VS05, consult the VS05 owner's manual, see
.
User's Manuals
R5976255 A CS4 (2001-03)
TLAS
easy adjustment of projector via IBM PC (or compatible) or MAC con-
nection
allow storage of multiple projector configurations and set ups.
wide range of control possibilities.
address range from 0 to 255.
sending data to the projector or copying the data from the projector to a
hard memory device (hard disc, floppy, etc.).
10 Service Mode
.
) can switch up to 5 Composite Video sources, 3 Super Video
.
9 Installation Mode
.
12.5.2
5-14