Table of Contents
Advertisement
7.1 Adjustment mode
You are now in the
'Adjustment Mode'
! The cursor key (
RCU
for adjustments.
! The
and
ENTER
! The
key can be used to terminate the adjustment mode while any path selection menu
ADJUST
is displayed.
There are 3 possible paths to follow once in the
!
Installation
Installation should be selected if a new input module is installed or a new source is connected
to an existing input module. Also when the projector is relocated in a new configuration.
!
Random Access
Random Access should be selected to set up a new source.
!
Service
Service should be selected if the user intends to change general settings such as password, lan-
guage, address, etc.or some service actions as reset lamp run time, panel adjustments, etc. or
get set-up information.
Some items in the
Adjustment
projector asks to enter your password (Password protection is only available when the password
strap on the controller module is
password strap).
7.1.1 Password
The password contains 4 digits.
! Enter the digits with the numeric keys.
Example: 2 3 1 9
The first digit position is highlighted. Enter with the numeric keys. The highlighted square jumps
to the next position. Continue until all 4 digits are filled in.
When your password is correct, you gain access to the selected item.
When your password is wrong. the error message "Invalid password" is displayed on the screen.
Press
to continue and to return to the
EXIT
The factory programmed password is 0 0 0 0
Once the password is correctly entered, all other password protected items are accessible without
re-entering the password.
When re-entering the
lecting a password protected item.
For setting up your own password see chapter
R5976255 A
CS4 (2001-03)
TLAS
.
) or
or
keys (local
'+
'-'
keys are used to move forward and backward through the
EXIT
mode are password protected. While selecting such an item, the
, call an authorized service center to change the position of the
ON
Service menu
mode, it will be necessary to enter the password again when se-
Adjustment
) are used to make
keypad
. They are:
Adjustment Mode
.
10.2 Change Password
selections and also
menu
structure.
menu
7-2
Advertisement
Table of Contents
