Table of Contents
Advertisement
14.1 Faults
Faults
no display: lamp not ignited and fan of the
illumination unit not running
display is upside-down
the display is dark though the lamp is ignited
A
CS4 can not be controlled via the
TLAS
RCU
R5976255 A
CS4 (2001-03)
TLAS
cause/steps
The equipment is not connected to power sup-
ply. It must be supplied with suitable voltage
(see
12.3 Technical Data Of Electrical System
Power switch is off. Switch on power switch.
See
5.1.3 Switching on
The cover of the lamp housing is not installed
correctly, and the micro-switch in the housing
interrupts power supply. The cover sheet must
be fixed (see
11.2.1 Replacing the Lamp Module
change the configuration:
To change the configuration of the projector,
proceed as follows:
! Press
to start up the adjustment
ENTER
mode.
! Press the cursor key
.
'Installation'
! Press
to display the
ENTER
.
menu
! Press the cursor key
.
'Configuration'
! Press
to display the
ENTER
. The actual installed configuration
menu
will be highlighted.
Press the cursor key
up
corresponding configuration.
there is no signal applied. Check the input source
and the connections
point the front of the
RCU
on the screen. When using the wireless remote
control, make sure you are within the effective
operating distance (30m, 100ft in a straight line).
The remote control unit will not function prop-
erly if strong light strikes the sensor window or
if there are obstacles between the remote control
unit and the IR sensor.
)!
)!
or
to select
up
down
Installation
or
to select
up
down
Configuration
or
to select the
down
directly to the sensor
Table 14-1
14-2
Advertisement
Table of Contents
