Table of Contents
Advertisement
method 2:
! Press
to activate the digits
ENTER
! Push the cursor key
! Push the cursor key
! When finished press
method 3
! Counting up or down by pushing the cursor key
How to find the correct values for the displayed item?
During the installation of a file with
and the interlaced mode are automatically measured and filled in the menu table. These values will
be available when starting up the
Do not adjust these settings on an active file, they are used to identify the input
source file.
If the value for
Horizontal Total Pixels
projected image) will be seen in the image. Select
zero bars (hint: if the number of bars increase, adjust in the other direction).
The
determine the width of the window on the screen. This value is normally given
Active Pixels
in the source specifications. If not, adjust until full image is displayed (no missing pixels).
gives the number of pixels between the beginning of the input signal and the start
Horizontal Start
of the video information in the signal.
The
Horizontal Period
The
Vertical Total Lines
is the number of horizontal lines determining the height of the projected image. This
Active Lines
value is normally given in the specification of the source. If not, adjust until full image height is
displayed (no missing lines)
gives the number of lines between the start of the input signal and start of the image
Vertical start
on the screen.
[On] or [Off]: this selection is automatically filled when active file has to be edited. If
Interlaced
the image is wrong due to mismeasurement, use the
(for interlaced images, one frame contains two fields).
AMDS = automatic mode detection & synchronization)
Read AMDS (
file with
, the system automatically measured the horizontal period, the total vertical lines
LOAD
and the interlaced mode. When selecting
items.
R5976255 A
CS4 (2001-03)
TLAS
or
to select the changing digit.
right
left
or
to scroll to desired digit.
up
down
to confirm.
ENTER
, the horizontal period, the total number of vertical lines
LOAD
procedure of an active file.
EDIT
is wrong, sampling mistakes (small vertical bars in the
is already filled in with the correct value of the active file.
are already filled when an active file is selected to be edited.
Read AMDS
or
.
right
left
and adjust the pixel quantity. Adjust for
Total
key to toggle between [On] and [Off].
ENTER
During the installation of a
:
, the system re-measures the above indicated
8-4
Advertisement
Table of Contents
