Table of Contents
Advertisement
8.1 File Service
Before using a new source, a correct file has to be installed. The projector's memory contains a list
of files corresponding to the most used sources. When the new source corresponds with one of
these files, the file can be loaded and saved for future use. When there is a little difference, the file
can also be loaded and then edited until the source specs are reached.
File loading can be done automatically (see
To enter the
File Service
! Push the cursor key
! Press
to select.
ENTER
! The
File service menu
returns to the
!
EXIT
returns to operational mode.
!
ADJUST
The following file manipulations are possible:
Load
Edit
Rename
Copy
Delete
Options
8.1.1 Load File
! Push the cursor key
! Press
to select.
ENTER
The
displays the corresponding files depending on the installed filter. This filter can be
Load menu
or
.
Fit
All
:
all files that can be loaded will be displayed.
All
:
only the best fitting files will be displayed (with a distinction of ± 2 lines and line duration
Fit
distinction of ± 300 ns, if nothing is found within this small area, the projector continues
searching until it finds something.)
To change the filter :
! Push the cursor key
! Press
to toggle the annotation between brackets.
ENTER
R5976255 A
CS4 (2001-03)
TLAS
, handle as follows:
or
to highlight
up
down
will be displayed.
.
Path selection menu
installation of a file for a new source
editing a loaded file to the source specs
renaming a file
copying a file to a new file
deleting an existing file
way of sorting the files & automatic file loading
or
to highlight
up
down
or
to highlight
left
right
8.1.6 File Options
.
'File Service'
.
'Load'
.
'filter list'
).
8-2
Advertisement
Table of Contents
