10.1 Identification
To display the
Identification screen
! Push the cursor key
! Press
to display the Identification screen.
ENTER
The Identification screen gives an overview of:
type of projector
projector address
software version
installation configuration
baud rate
text
projector serial number
projector run time
R5976255 A
CS4 (2001-03)
TLAS
:
or
to highlight
up
down
Barco ATLAS 67 CS4 or ATLAS 84 CS4
to change the address of the projector, see
Address
possible installations:
Front/Ceiling
Front/Table
Rear/Ceiling
Rear/Table
To change the
installation configuration
chapter
transfer speed for communication with an IBM PC (or compatible) or
MAC. The baud rate of the projector must be the same as the baud
rate of the connected computer. When there is a difference, consult
chapter
10.5 Change Baudrate PC
or
ON
OFF
indicates the fabrication number of the projector. This number can be
useful when calling for technical assistance
gives the total run time since the first start up. All projectors leave
the factory with a run time of approximately 24 hours.
.
'Identification'
.
10.4 Change Projector
follow the instructions in
10-2