Cutting Bar Code Tapes - Leuze electronic BPS 8 Original Operating Instructions

6.1.2

Cutting bar code tapes

NOTE
Bridging gaps!
Any mechanical gaps may have to be bridged when affixing the bar code tape.
 Smaller gaps (up to around 10mm) can be covered with the tape.
 For wider gaps we recommend cutting out the label over the gap at the marked cut
mark.
 In chemically aggressive environments, the bar code tape should be cut out over
mechanical gaps. Since the tape is highly resistant to chemical loads only on the front
side, exposure of the adhesive side should be avoided.
If necessary, the BCB is cut at the indicated cut marks ((see figure 6.1)).
BCB8 000036
A Cut mark
Figure 6.1: Cut mark on the bar code tape
Leuze electronic
A
BCB8 000039 BCB8 000042
BPS 8
Mounting and installation
BCB8 000045 BCB8 000048 BCB8 000051
33