Mounting The Bps 8 - Leuze electronic BPS 8 Original Operating Instructions

6.2

Mounting the BPS 8

There are different types of mounting arrangements for the BPS 8:
1. Directly, using the 2 through holes in the housing.
2. Using the BT 8-01 mounting device on the through holes.
3. Using the BT 8-0 mounting device on the dovetail.
BPS 8 SM 102
A
A Reading window with front beam exit
B Reading window with lateral beam exit
C Ø 4.4mm through holes for mounting
D Dovetails and two M4 mounting threads at the rear and bottom side of the device
E M12 connector, turnable
Figure 6.7: BPS 8 mounting options
CAUTION
For the position calculation, the scanning beam of the BPS 8 must be incident on
the bar code tape without interruption. Ensure that the scanning beam is always
incident on the BCB when the system is moving.
Leuze electronic
D
C
D E
BPS 8
Mounting and installation
BPS 8 SM 100
D
B
D
C
E
41