Sw In/Out Socket - Switching Input And Switching Output - Leuze electronic BPS 8 Original Operating Instructions

7.4.2 SW IN/OUT socket – switching input and switching output
SWIN
4
5
FE
3
GND
SW IN/OUT
M12 socket
(A-coded)
Figure 7.8: MA 8-01/MA 8-02 – Pin assignment SW IN/OUT socket
CAUTION
Degree of protection IP 67!
Degree of protection IP 67 is achieved only if the connectors and caps are screwed into
place!
The switching input/switching output are programmed via the parameters in the BPS
Configuration Tool configuration software. For further information, see Chapter 8.2,
Page 62 et seq.
CAUTION
Connecting a sensor with standard M12 connectors!
If you use a sensor with a standard M 12 connector, please note the following:
 Use only sensors on which the switching output does not lie on pin 2 or sensor
cables on which pin 2 is not assigned. Otherwise, the switching output is not pro-
tected against feedback on the switching input. If the inverted sensor output lies on
pin 2, erroneous behavior of the switching output will result.
Leuze electronic
SW IN/OUT (5-pin socket, A-coded)
Pin
VOUT
1 1
2
2
3
SWOUT
4
5
Thread
Name
Voltage supply for sensor system (VOUT
VOUT
identical to VIN at PWR IN)
SWOUT Switching output
GND GND for the sensor system
SWIN Switching input
FE Functional earth
FE Functional earth (housing)
BPS 8
Electrical connection
Comment
57