Table of Contents
Advertisement
17.12.0
Keel Offset
The keel offset can be set to cause the Fish Finder to display an offset depth below the keel
or the actual water depth from the surface. To setup to show the depth below the keel, enter
a negative depth value or a positive depth to show offset from the transducers face to the
water surface.
17.12.1
Calibrate Water Speed
Used to calibrate the Water Speed readings from the transducer. Adjustment can be made
from -10% to +10%.
17.12.2
Calibrate Water Temp
Used to calibration on the Water Temperature sensor in the transducer.
17.12.3
Set Defaults
Restores the factory settings.
17.13 ALARMS
The Alarms menu allows you to define alarm settings for Shallow Alarm, Depth Alarm and
Temperature Upper/Lower/Rate.
To set an Anchor Alarm, enter in a shallow water and deep water value above and below
your actual anchoring depth. The alarm will sound when the depth becomes shallower or
deeper than the settings.
17.13.0
Shallow Water
Triggers an alarm when depth becomes shallower than the set depth.
17.13.1
Deep Water
Triggers an alarm when depth becomes deeper than the set depth.
Page 124
Figure 17.13 - Alarms menu
CP190i and CPF190i
Advertisement
Table of Contents
