Keel Offset; Calibrate Water Speed; Calibrate Water Temp; Calibrate Aux Temp - Standard Horizon FF525 Installation And Operation Manual

5.7.0

Keel Offset

The keel offset can be set to cause the Fish Finder to display an offset depth below the keel
or the actual water depth from the surface. To setup to show the depth below the keel, enter
a negative depth value or a positive depth to show offset from the transducers face to the
water surface.
5.7.1

Calibrate Water Speed

Used to calibrate the Water Speed readings from the transducer. Adjustment can be made
from -10% to +10%.
5.7.2

Calibrate Water Temp

Used to calibration on the Water Temperature sensor in the transducer.
5.7.3

Calibrate Aux Temp

Allows the calibration of the Aux Temperature sensor connected to the Optional Connection
wires.
5.7.4

Set Defaults

Restores the factory settings.
5.8

ALARMS

The Alarms menu allows you to define alarm settings for Shallow Alarm, Depth Alarm and
Temperature Upper/Lower/Rate.
Page 36
Figure 5.7 - Transducer Setup menu
FF525