Software Configuration; User Management - Euronda E9 Next 18L Instruction Manual

1 - Programme language, click on modify to change the interface language:
2 - User data entry: this data then appears on the cycle print header. The "Read from machine" function
allows you to import data from the device (if previously entered) while the "Write into machine" function
allows you to export data from this screen to the device.
3 - User logo can be used to enter a small drawing or photo. This photo appears in the header of the cycle
print page near the user data. Operator name, instead, can be used for reasons of traceability to indicate
the name of the person performing sterilisation operations.
4 - Setting the password: the password is requested whenever you attempt to delete one or more cycles
from the file screen, delete the external memory or modify the password. When entering the password,
you are asked to confirm it by typing it in again. The predefined password is "certificate".
5 - Default e-mail: you may enter a predefined e-mail address in order to e-mail cycle data to a previously
entered address.
6 - Totally deletes the cycles in the SD Card memory.
NOTE: All modifications must be saved before they have any effect: after making a modification, hold
the cursor over any field and click on the

8.2.1 User management

To personalise the list of available users, once the SD card is placed in the PC, enter the configuration
menu, select board 2, then click "User Management".
At this point a table will be displayed, on which a list of personalised users can be entered. When clicking
"Write in E-memory" the list will be saved on the SD card and then detected by the sterilizer.
The steriliser can store up to 5 different users.
Turn the steriliser off and then on again so it detects the new user list.
8.2

SOFTWARE CONFIGURATION

button.
53
Aquafilter
E9 NEXT
E9_Next_Ing_rev03 – 10/10/2018