Manually Stopping A Cycle After The Sterilization Phase; Power Blackouts; Resetting The Unit After An Interruption Caused By An Alarm; Settings - Euronda E9 Next 18L Instruction Manual

Aquafilter
E9 NEXT

7.4.2 Manually stopping a cycle after the sterilization phase

If a cycle is stopped after completion of the sterilisation phase but before the end of the drying phase, the
load in the boiler is to be considered as STERILE BUT WET. As the load has not been dried correctly, it is
not possible to preserve it and it must therefore be considered as being for IMMEDIATE USE. The sterile but
wet load screen appears on the display. The door is locked. Touch the screen to release it.
7.5

POWER BLACKOUTS

Power cuts may occur during the operation of the unit, caused by the electricity provider. In this case, the E
02 alarm message appears (see "Appendix 9 Troubleshooting").
7.6

RESETTING THE UNIT AFTER AN INTERRUPTION CAUSED BY AN ALARM

To recover the unit after an interruption caused by an alarm, touch the screen to release the door and return
to the Home screen. For further information, consult "Appendix 9 Troubleshooting".
7.7

SETTINGS

In the HOME screen, touch SETTINGS to access the settings menu.
Touch the arrows to scroll through the settings menu. Touch the central icon to return to the start screen.
This menu can be used to set the various operating parameters of the steriliser.
38
E9_Next_Ing_rev03 – 10/10/2018