Start-Up, Execution And End Of A Cycle - Euronda E9 Next 18L Instruction Manual

Important: set the load to sterilise in the highest possible position of the tray
support.
For enveloped loads over the indicated weight it is not guaranteed a correct drying.

7.2.1 Start-up, execution and end of a cycle

While the steriliser is performing a sterilisation or test cycle, the following screen appears on the display. This
shows:
• at the top the cycle name (B 134 in this case);
• below, an indicator of the cycle stage: pre-vacuums, sterilisation, drying;
• below, the instantaneous temperature value in °C, of the pressure in bars, an hourglass with an
approximate estimate of the time left to the end of the cycle, and the padlock symbol, to indicate that the
door is locked
At the bottom, the hand icon for manually stopping the cycle and the "i" icon for accessing the menus giving
detailed information on the values read by the probes.
If the icon is touched when a cycle is being run the following screen appears requesting confirmation of the
manual stop. Touching the hand icon again will confirm the intention to stop the machine, and the machine
will therefore start the manual stop procedure. If the left-arrow icon is touched the previous screen appears.
31
Aquafilter
E9 NEXT
E9_Next_Ing_rev03 – 10/10/2018