Information On Process Parameters - Euronda E9 Next 18L Instruction Manual

Door release
ATTENTION: A safety pin automatically locks the door when the cycle starts. The pin only returns
to its seat at the end of the cycle. Attempting to open the door with the door safety device
applied may seriously damage the closing system. Always wait for the end of cycle signal
on the LCD display before opening the door.
In the event of an alarm, the door can only be opened after giving consent by touching the screen
(see 7.6).
CAUTION: LOAD NOT STERILE, HANDLE WITH CARE.

7.2.2 Information on process parameters

Additional information on the parameters of the currently running cycle can be obtained by pressing "i" on the
Cycle in progress screen.
The next screen shows the type of cycle currently running, and the number of cycles completed. Below is the
instantaneous reading of the probes on the steriliser and the name of the current phase (at the top). Below
that, is the icon with the left arrow, to return to the previous screen.
* If Aquafilter is set to ON, the conductivity measure appears.
33
Aquafilter
E9 NEXT
E9_Next_Ing_rev03 – 10/10/2018