Euronda E9 Next 18L Instruction Manual page 26

Fig. 6.8-1
Later, when using the unit, whenever the water reaches the MIN level, the "MIN" message will appear and,
until the water tank is filled, it will not be possible to perform any work cycle and certain tests.
Adding clean water
1. Empty the inner tank for collecting used water as described below in the par. "Emptying used water".
2. Fill the clean water tank with fresh clean water (1 di Fig. 6.8-1).
WARNING: always use good quality clean water (Appendix 8 "Quality of process water"). To
ensure correct machine operation it is fundamental to use distilled water only.
CAUTION: before transporting the unit, drain both water tanks. Use the supplied tube.
To empty the clean water tank, remove the discharge section cover (3 of Fig. 6.8-2) and fit the
end of the tube with the connector to the connector with the light blue button at the bottom of the
front panel (1 of Fig. 6.8-2), and place the other end into an empty container.
25
Aquafilter
E9 NEXT
E9_Next_Ing_rev03 – 10/10/2018