Xerox WorkCentre 5020 Service Documentation page 142

9. While maintaining tension on the Carriage Cable (black) at the rear left side, disconnect it
(Figure 7).
1 Remove the Cable Spring.
2 Disconnect the Carriage Cable.
3 Remove the Carriage Cable from the pulley.
Repairs and Adjustments
REP 10.3.1
Figure 7
10. Use tape to secure the Carriage Cable (black) that was disconnected in step 9 so that it
does not get separated from the Cable Supply Drum (Figure 8).
1 Secure the Carriage Cable with tape.
July, 2007
4-70
Figure 8
Initial Issue
WorkCentre 5020