Xerox WorkCentre 5020 Service Documentation page 28

Error
Code Error Name/Explanation/I/O Diagnostic Codes/Check Items
Error Name
STM L/H Cover open
Explanation
Access Cover 2 is open.
I/O Diagnostic Codes (How to Enter the Diagnostic Mode)
[01-10] STM Interlock Switch
Check Items
E6-2
• Check that Access Cover 2 closes correctly.
• Check that the STM Interlock Switch is correctly installed and that the electrical connection is good.
• Check that the following wires are connected securely with good electrical contact. If there is no problem, replace the STM Interlock Switch
(PL 11.5).
– Wire between STM Interlock Switch J173-2 ( P/J173) and STM PWB J542-9 ( P/J542)
– Wire between STM Interlock Switch J173-1 and STM PWB J542-10
• Replace the STM PWB (PL 11.5) (REP 11.5.2), the LVPS (PL 8.1) (REP 8.1.2), and the AIOC PWB (PL 8.1) (REP 8.1.1) in that order.
Error Name
Nup NG Out Of Range
Explanation
The magnification is not within the range of 50 to 200% during Nup.
Check Items
E8-1
• Press the [Stop] button on the Control Panel.
• Press the [Paper Supply] button on the Control Panel.
• Press the [Special Copy] button on the Control Panel.
• Press the [Original Size Input] button on the Control Panel.
• Press the [Clear All] button on the Control Panel.
Error Name
Nup Paper direction mismatch
Explanation
The paper orientation of the document and the tray are not aligned during Nup.
Check Items
E8-2
• Press the [Stop] button on the Control Panel.
• Press the [Paper Supply] button on the Control Panel.
• Press the [Special Copy] button on the Control Panel.
• Press the [Original Size Input] button on the Control Panel.
• Press the [Clear All] button on the Control Panel.
Status Indicator RAPS
July, 2007
2-16
Record in
Error Log RAP BSD
CH7.2
X -
Figure 2
CH3.2
X -
Figure 2
CH3.2
X -
Figure 2
Initial Issue
WorkCentre 5020