Rep 5.1.4 Fuser Roll - Xerox WorkCentre 5020 Service Documentation

REP 5.1.4 Fuser Roll

Parts List on PL 5.1
Removal
To avoid personal injury or electrical shock, ensure that the machine is completely off
before disassembling or adjusting. Turn OFF the power and unplug the machine.
The Fuser and Exit Transport are hot. Do not work on them until they are cool enough.
Do not touch the glass part of the Fuser Lamp unless you are are wearing gloves.
1. Remove the Fuser Lamp (REP 5.1.3).
2. Remove the Fuser Cover (Figure 1).
1 Remove the 2 Screws.
2 Remove the Fuser Cover.
NOTE: Do not lose the Cover Mount (Figure 2).
Fuser Cover
Figure 1 Removing the Fuser Cover
Initial Issue
WorkCentre 5020
WARNING
WARNING
CAUTION
Screws
3. Remove the Stripper Finger Assembly (Figure 2 and Figure 3).
1 Remove the Screw.
2 Remove the Stripper Finger Assembly.
Cover Mount
Figure 2 Fuser Cover Removed
Stripper Finger Assembly
Screw
Figure 3 Removing the Stripper Finger Assembly
July, 2007
4-35
Stripper Finger Assembly
Fuser Cover
Repairs and Adjustments
REP 5.1.4