Honeywell 2MLL-PSRA User Manual page 57

To set I/O parameter, perform the following steps.
Step
1
In the SoftMaster-NA, click Online > I/O Information.
The I/O information dialog box appears.
Verify whether the I/O information matches with the actual system
configuration.
The following figure shows the I/O information.
2
If the I/O information matches with the actual module configuration, click the
I/O Sync. button and match the I/O information.
After synchronization, the following message appears.
3
If module mismatch error appears, verify whether ERR LED is off or not.
Check whether all the modules are registered at project window.
R210 Pnet I/F Module 2MLL-PSRA, 2MLL-PSEA User's Guide
November 2011
5. Communication Programming
5.2. How to register Profibus-DP remote module
Action
Honeywell
57