Download  Print this page

Honeywell 2MLL-PSRA User Manual Page 62

Pnet i/f module.
Hide thumbs

Advertisement

5. Communication Programming
5.3. How to set Pnet slave I/F module parameter
Step
11
Under Time settings, set the Waiting time for both the channels.
12
Under Active mode, from the operation mode list, choose the operation
mode for both the channels.
13
Click OK.
High-speed Link Communication Diagnosis
You can check the status of the data communication through the LED in the
communication module.
When you want to monitor detailed high-speed link data for each block, monitor the
high-speed link service at the system monitor window. Then, you can monitor "Service
count" and "Error information" for each block.
Parameter setting by SyCon
Perform the following steps to set the parameters using SyCon.
Step
1
Start the SyCon tool.
The SyCon window appears.
2
Click Insert > Slave or from the top left toolbar, select
master to insert slave.
The Insert Slave dialog box appears.
62
Pnet I/F Module 2MLL-PSRA, 2MLL-PSEA User's Guide
The following three types of parity bit can be specified for Snet I/F
module.
None: When the parity bit is not used.
Even: To maintain even number of 1's. If the number of 1 bit in
one byte is even, 0 is sent as the parity bit.
Honeywell
Action
Action
and then click
R210
November 2011

Advertisement

Table of Contents

   Also See for Honeywell 2MLL-PSRA

   Related Manuals for Honeywell 2MLL-PSRA

This manual is also suitable for:

2mll-psea

Comments to this Manuals

Symbols: 0
Latest comments: