Download  Print this page

Figure 8 - Installing The Duct - Honeywell 2MLL-PSRA User Manual

Pnet i/f module.
Hide thumbs

Advertisement

Install the duct for wiring if necessary. But, if the distance between upper part or
lower part of PLC and duct is smaller than the below figure, then you should
consider the following:
a)
In case of installing on the upper PLC, the height of wiring duct should be less
than 80mm for good ventilation.
In case of installing on the lower PLC, consider minimum radius of the cable.
In case the equipment is installed in front of the PLC (inside the door) to avoid
the effect of radiant noise or the heat, separate it from the PLC of distance more than
100mm.
R210
Pnet I/F Module 2MLL-PSRA, 2MLL-PSEA User's Guide
November 2011
Figure 8 – Installing the duct
Honeywell
3. Installation and wiring
3.2. Wiring
33

Advertisement

Table of Contents

   Also See for Honeywell 2MLL-PSRA

   Related Manuals for Honeywell 2MLL-PSRA

This manual is also suitable for:

2mll-psea

Comments to this Manuals

Symbols: 0
Latest comments: