Download  Print this page

Table 15 - Communication Flag List - Honeywell 2MLL-PSRA User Manual

Pnet i/f module.
Hide thumbs

Advertisement

5. Communication Programming
5.1. How to set master module
To use SoftMaster-NM for Pnet remote I/F module, perform the following steps.
Step
1
Execute SoftMaster-NM.
2
Click Online > Read IO Information or click
You can read the I/O information of the Pnet remote I/F module.
3
Connect Pnet remote I/F module to read I/O information from High-speed
Link.
4
Designate device and address used in program to connect I/O point to the
slave module, which is composed in SyCon with PLC program.
5
Click Online > Write Parameter (Standard Settings, HS Link, P2P) or click
It starts writing High-speed Link parameter to Pnet remote I/F Module.
6
Click Online > Enable Link (HS Link, P2P) or click
It enables Pnet remote I/F module's communication.
High-speed Link communication status flag information
The following table indicates the communication flag list corresponding to High-speed
Link Number.
No.
Keyword
L000000
_HS1_RLINK
52
Pnet I/F Module 2MLL-PSRA, 2MLL-PSEA User's Guide
.
Table 15 – Communication flag list
Type
Contents
All stations of High-
Bit
speed Link No.1 are
normal.
Honeywell
Action
.
.
Description
It indicates normal status of all stations,
which operate according to parameter set in
the High-speed Link.
If the following condition are met, it would be
turned ON.
a)
All stations set in parameter are RUN
mode and there is no Error.
b)
All data blocks set in parameter operate
properly.
R210
November 2011

Advertisement

Table of Contents

   Also See for Honeywell 2MLL-PSRA

   Related Manuals for Honeywell 2MLL-PSRA

This manual is also suitable for:

2mll-psea

Comments to this Manuals

Symbols: 0
Latest comments: