Bosch Rexroth AG
Device description
Fig. 12-6: "Welcome" dialog
12.5.1 Hardware data
The "Hardware" site lists all device-specific data of the XM12 control in a table.
Material index
●
Hardware type plate
●
Serial number
●
Part number
●
12.5.2 Network settings
The "Network" site is used to configure the network settings during the initial
commissioning. The currently configured network settings are shown in the fol-
lowing three fields and can also be changed using these fields:
IP address
●
Gateway
●
Subnet mask
●
Enter a valid network setting and write that setting to the control (press the
Write configuration button). If writing the network settings is completed suc-
cessfully, a message is displayed in the header area of the site. The Reboot con-
trol button is additionally displayed. It is used to restart the control and thus ap-
plies the network setting.
44/61
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Controls
DOK-CONTRL -IC*XM2*****-IT03-EN-P