Bosch Rexroth IndraControl XM21 Operating Instructions Manual page 52

Bosch Rexroth AG
Device description
– System mode: Control was started with the previously installed system
firmware
Installed system firmware version ("none" if no system firmware was instal-
●
led)
Press the buttons for the following actions:
Reboot into "Initial mode": Reboots the system and restarts the initial mode
●
Reboot into system mode: Boots an installed system firmware
●
Archive SYSTEM|OEM|USER: Backs up the complete directory structure of all
●
partitions to a firmware archive (.fw file), also refer to
TEM|OEM|USER" on page 46
Restore SYSTEM|OEM|USER: To restore a system installation from a backup
●
file, also refer to
Factory reset: Restores the delivery state of the control. The complete direc-
●
tory structure is reset
Caution: Loss of data!
An existing system firmware installation is deleted. The network set-
tings are reset to its delivery state.
Archive SYSTEM|OEM|USER
This function is used to archive the internal storage medium. This includes all
partitions and their file and directory structure. After the process, an ".fw" file is
stored on the user partition of the control. This file can be loaded to a local PC
at a later point in time (see
The file name of a system archive can consist of 4-16 alphanumerical
characters and has to have the file extension ".fw".
The backup can only be started if the selected file name corre-
sponds to the archive rules. During as well as after the backup, a
corresponding message is displayed.
46/61
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
chapter "Restore SYSTEM|OEM|USER" on page 48
chapter 12.5.4 "File manager" on page
Controls
chapter "Archive SYS-
50).
DOK-CONTRL -IC*XM2*****-IT03-EN-P