Controls
10.3 Mounting the control
NOTICE
Place the modules vertically on the mounting rail and remove them vertically
from the mounting rail as well.
Fig. 10-5: Positioning and removing modules only vertically
NOTICE
Before mounting or demounting components, disconnect the control - includ-
●
ing its components - from voltage
Connect the voltage only after the control and its components have been set
●
up
NOTICE
Fasten the top-hat rail adequately
●
Connect the top-hat rail to a functional ground
●
Mount the control on the top-hat rail as the top-hat rail is among other things
●
used for heat dissipation and grounding
Install the control in a control cabinet or an appropriate housing
●
Mounting the control bus base module
1. Press the control bus base module on the top-hat rail until all latchings are
safely closed.
DOK-CONTRL -IC*XM2*****-IT03-EN-P
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Mounting, demounting and electric installation
Damages at the contacts by tilting the modules
Destruction of components due to plug mount-
ing under voltage!
Possible damage to property due to improper
mounting of the top-hat rail
Bosch Rexroth AG
19/61