Extension Bus; S20 Interface; Control Bus Base Module - Bosch Rexroth IndraControl XM21 Operating Instructions Manual

Controls
No. Name Connection type
S20 bus
④
SD Slot for SD card
⑤
XF30 USB host
⑥
USB 2.0
XD1 24 V plug
⑦
U
XF5 Ethernet
⑧
(TCP/IP, RT Ethernet)

Extension bus

⑨
Tab. 9-1: Control interfaces
9.2 Extension bus
Up to three extension modules can be freely connected at the left of the control.
The extension modules have to be attached without any gaps via the extension
bus base modules on the left side of the IndraControl XM21/XM22 and supplied
with the same 24 V supply voltage. Switch on and off the 24 V supply voltage of
the extension modules synchronously with the IndraControl XM21/XM22.

9.3 S20 interface

Up to 63 S20 modules can be connected to the S20 interface on the right of the
IndraControl XM21/XM22 via S20 bus base modules. The number of connecta-
ble modules depends on the total current consumption of the S20 modules. The
IndraControl XM21/XM22 can provide up to 2 A for the power supply of the S20
modules.

9.4 Control bus base module

The control bus base module is connected at the bottom side of the
IndraControl XM21/XM22. The control bus base module is available in two var-
iants:
BUSMODUL XA-BS01 connects the IndraControl XM21/XM22 with the S20
●
modules on the right control side
BUSMODUL XA-BS02 connects the IndraControl XM21/XM22 with the S20
●
modules on the right control side and the extension modules on the left con-
trol side
DOK-CONTRL -IC*XM2*****-IT03-EN-P
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Connector type
(Integrated)
Bus base module
32-pin
–
USB TYPE A-socket
4-pin
4-pin
LS
RJ45 socket
8-pin
Bus base module
32-pin
Bosch Rexroth AG
Interfaces
Mating connector and cable
(From outside)
Bus base module for S20 I/O
modules
32-pin
SD card
USB TYPE A-plug
(4-wire)
(4-wire)
RJ45 plug
(Twisted pair, 4-/8-wire)
Bus base module for exten-
sion modules
32-pin
15/61