8/27
Standards
ventilation holes. In particular, bend cables away from the ventilation holes as
near to the connectors as possible. Note that cooling is required for the module
holder and the base plate.
7 Technical Data
7.1 General
Requirements on Mains Circuits.
Mains Circuits of overvoltage category II up to 300 V AC rms.
●
7.2 24V Power supply ratings
The 24V System input power specifications are listed in the following table.
Input power
24V System
Tab. 7-1: 24V power supply ratings
8 Standards
8.1 Used standards
The components of the system housing correspond to the following standard.
IEC61010-1:2010
●
measurement, control and laboratory use - Part 1: General requirements)
IEC61000-6-2:2005) (Electromagnetic compatibility (EMC) - Part 6-2: Generic
●
standards - Immunity for industrial environments)
IEC61000-6-4:2018 (Electromagnetic compatibility (EMC) - Part 6-4: Generic
●
standards - Emission standard for industrial environments)
8.2 CE marking
Declaration of Conformity
Fig. 8-1: CE logo
The system housing described in the present instructions, complies with the
requirements and the target of the following EU directive and with the following
harmonized European standards:
Low Voltage Directive 2014/35/EU
●
Bosch Rexroth AG R911383228_Edition 04
UN
DC 24V
(Safety
requirements
NYCe 4000 Linear motion control sys-
IN
Fan
1.5A
for
electrical
tem
IN
Natural convection
1.5A
equipment
for