Demounting The Control And The Control Bus Base Module; Demounting Steps - Bosch Rexroth IndraControl XM21 Operating Instructions Manual

Bosch Rexroth AG
Mounting, demounting and electric installation
Mounting extension bus base modules
1. Press the extension bus base modules for the extension modules on the
top-hat rail on the left next to the control bus base module until all latch-
ings are safely closed (see (A) in the following figure).
2. Move the first extension bus base module (see (B) to the right and connect
the extension bus base module with the bus base module of the control
(see (D) in the following figure).
3. Move the other extension bus base modules to the right until all bus base
modules are connected with each other (see (C) in the following figure).
Fig. 10-10: Connect extension bus base modules among each other and with the con-
trol bus base module
Mounting extension modules to the extension bus base modules
1. Press the extension modules on the premounted extension bus base mod-
ules.

10.6 Demounting the control and the control bus base module

To demount, use a common tool such a slotted screwdriver with a
2.5 mm blade.

10.6.1 Demounting steps

NOTICE
Before mounting or demounting components, disconnect the control - including
its components - from voltage.
22/61
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Destruction of components due to demounting
under voltage!
Controls
DOK-CONTRL -IC*XM2*****-IT03-EN-P