Led Block Of 10 - Bosch Rexroth IndraControl XM21 Operating Instructions Manual

Controls
The following functions are assigned to the LEDs on the XD1 plug:
LED Color
U Green
L
ON Green
T Red
Tab. 12-1: LED functions on the XD1 plug

12.1.2 LED block of 10

XF1 XF2
S L S L
XF5
L S
XF30
XD1
ON
UL T
24V 0V
USV 0V
Fig. 12-3: LED block of 10
The LED block of 10 is positioned on the higher located area of the control hous-
ing.
The following functions are assigned to the LEDs at running system firmware:
DOK-CONTRL -IC*XM2*****-IT03-EN-P
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Function
24 V supply voltage connected and within the permitted range
All internally programmed function blocks are loaded. These also in-
clude internally programmed function blocks of connected modules. If
this LED is not green, loading for internally programmed functions
block of an extension module or of the control failed. In this case, ini-
tiate a fallback. Refer to
42.
The temperature is critical
●
If the control cannot be operated anymore, the maximum tempera-
●
ture was exceeded and the control was switched off. The control
can only be operated when interrupting the voltage.
SF2
XF31
IndraControl XM21
s STA
DIA1 ERR
DIA2 BT
DIA3 D
DIA4
E
XG10
SF1
Run
Stop
Clear
Device description
chapter 12.4 "Fallback and recovery" on page
DIA1
DIA2
Bosch Rexroth AG
s STA
ERR
BT
DIA3
D
DIA4 E
35/61