Adding Ipsi Information - Avaya S8500 Manual

An Asterisk (*) to the right of the
displayed, it is not the correct one; Avaya Communication Manager does not have the subnet
information. After verifying the displayed information, submit this form with or without changes
to update Communication Manager with the correct subnet information.
1
Type change system-parameters ipserver-interface
change system-parameters ipserver-interface
SERVER INFORMATION
Primary Control Subnet Address: 172. 22.
Secondary Control Subnet Address:
OPTIONS
IPSI Control of Port Networks: enabled
2
Verify that the Primary Control Subnet Address is correct.
The subnet address must match the most significant 3 octets (the first 3 groups of digits in the
subnet address) of the Server IP address.
An Asterisk (*) to the right of the
displayed, it is not the correct one; Avaya Communication Manager does not have the subnet
information. After verifying the displayed information, submit this form with or without changes
to update Communication Manager with the correct subnet information.
3
Set the
4
Set the
5
Press Enter to effect the change.

Adding IPSI information

1
Type
add ipserver-interface PNnumber
information.
Installing the Avaya S8500 Media Server with an Avaya G650 Media Gateway
December 2003
IP SERVER INTERFACE (IPSI) SYSTEM PARAMETERS
IPSI Host Name Prefix:
Switch Identifier: A
NOTE: * indicates data changed on the server
CAUTION:
If the information displayed in the
changed on the media server. Use the Maintenance Web Interface; under Server
Configuration and Upgrades, click Configure Server to change the media server
configuration. Then return here to perform this step.
Switch Identifier: field to the switch ID letter (A thru J; A is the default setting).
IPSI Control of Port Networks:
NOTE:
The information you provide differs, depending on whether the IPSIs get static addresses
or they are assigned automatically through DHCP.
field means that although a subnet address is
Subnet Address
and press Enter.
0. 0*
. . .
Subnet Address field means that although a subnet address is
Subnet Address
field to enabled.
and press Enter to add the IPSI circuit pack
Customizing the media server
Page 1 of
field is not correct, it must be
1
91