Configuring The Network Interface Card; Confirming Original Ethernet Configuration; Configuring The Nic - Avaya S8500 Manual

Configuring the network interface card

Configuring the network interface card
This section describes the steps required to configure the optional network interface card (NIC) on the
Avaya S8500 Media Server. The components of this procedure include:
•

Confirming original Ethernet configuration

•

Configuring the NIC

•
Testing connectivity to customer's network
Confirming original Ethernet configuration
After the Media Server is back in service, check the original Ethernet configuration settings:
1
Go to the Configure Server Web page.
2
Confirm that the server's Ethernet configuration settings are the same as before.
Configuring the NIC
1
Under Server, click Configure Server
2
Click Continue through the review notices until you get to the xxx page.
3
Select Configure Individual Services and click Continue.
4
Select Set Identities and click Continue.
5
The following Ethernet ports are listed:
•
•
•
•
6
Using the drop-down menu, set the
a dedicated, separate Ethernet port.
7
Click Continue.
8
Fill in the following information for Ethernet 2:
•
•
•
•
9
Select "VLAN 802.1q priority tagging is enabled" if true.
10
Click Change. The status of the configuration update appears in the window.
When the update completes, the following message appears:
ethernet interfaces
78
on page 78
Control Network A: [default: Ethernet 0]
Services Port: [default: Ethernet 1]
Corporate LAN: [default: Ethernet 0]
Unused
IP address
Gateway
Subnet mask
Speed
.
Installing the Avaya S8500 Media Server with an Avaya G650 Media Gateway
on page 78
on page 79
field to Ethernet 2 to have the IPSI control on
Corporate LAN
Successfully configured
December 2003