Dialing Up To The Media Server; Maintenance Web Interface; Command Line Interface - Avaya S8500 Manual

Accessing the media server

Dialing up to the media server

To dial up, click the connection name or icon, if created. Once you are connected:
1
When prompted, enter your remote access login name and password.
2
When the "Start PPP now!" message appears, click
Complete dialog box, your computer is connected to the media server.
3
To open a Telnet session, click Start > Run to open the Run dialog box.
4
In the Run dialog box, type
actual active media server.
5
To use Avaya Site Administration, launch the software and select the switch you want to dial into.
See Installing Avaya Site Administration
and build a record for a particular media server.

Maintenance Web Interface

You can access the Maintenance Web Interface either by connecting directly to the services port (port 2
[Eth1]) on the media server (see
Media Server,
Netscape 6.2 and MS Internet Explorer 5.5 or 6.0.
When connected directly to the media server, you also must disable all proxy servers.
1
Click Tools > Internet Options.
2
Select the Connection tab.
3
In the LAN Settings box (lower right-hand), check "Bypass proxy server for local addresses."
4
Click OK, OK.
To use the Maintenance Web Interface:
1
Open the MS Internet Explorer Web browser.
•
•
2
When prompted, log in.

Command line interface

Telnet: To use a command line interface in a Telnet window:
1
Click Start > Run to open the Run dialog box.
•
•
2
When prompted log in.
294
telnet IPaddress
Figure 111, Services laptop computer connected directly to the S8500
on page 292) or connecting over the customer's network. The browsers supported are
If a direct connection, in the
If a remote connection, in the
name of the specific media server.
If a direct connection, type
If a remote connection, type in the IP address of the active media server. (SAT commands
are usable only on the active media server only.)
Installing the Avaya S8500 Media Server with an Avaya G650 Media Gateway
Done . When you see the Connection
and click OK, where IPaddress is the address of the
on page 295 for information on installing the software
field, type
Location/Address
field, type in the IP address or DNS host
Location/Address
and click OK.
telnet 192.11.13.6
.
192.11.13.6
December 2003